|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
;
This service Manual for my JVC AV29BF10EES is very helful. Everything is show in detailed diagrams!!!! If you need really good source of information for this type JVC you are on the right place. I am satisfied and very glad for this excellent book. Thank you.
;
Great service, great value like always!!!
Some of the writing is a bit blur but all is usable.
A+++++++++++++++++
9. Vertical Center Input signal: Crosshatch Measuring instrument: Pattern generator/PAL 9-1. Set the TV to the "Normal I" mode. 9-2. Choose V. Shift from the menu screen. 9-3. Adjust the "Vol +/-" buttons on the remote control so that the dot mark at the center of crosshatch is positioned at the vertical center of screen.
10-2. S-Correction 1) Choose V. S Cor from the menu screen. 2) Perform adjustment in the same way as with 6-1 Slope. * Repeat adjustments 10-1 and 10-2 so that A=B=C is available. 10-3. Amp 1) Choose V. Amp from the menu screen. 2) Adjust the "Vol +/-" buttons on the remote control so that the dot mark at the center of crosshatch is positioned at the vertical center of screen, the circle is a perfect circle, and each crosshatch is square. * If vertical center is not correct, perform adjustment in 5. Vertical Center again.
CRT center mark
Fig.9-1
A
10. Vertical Size Input signal: Crosshatch (with circle) Measuring instrument: Pattern generator/PAL Set the TV to the "Normal I" mode for adjustment items 10-1 _ 10-3. 10-1. Slope 1) Choose V. Slope from the menu screen. 2) Adjust the "Vol +/-" buttons on the remote control so that the vertical length of each square is equal (A=B=C).
A
Fig.10-2
B
11. AGC Input signal: Color bar (ANT RF=Input) Measuring instrument: Pattern generator/PAL Test point: 1501 6 pin RF AGC 11-1. Receive the pattern generator frequency at Pr91. 11-2. Connect an oscilloscope to the test point. 11-3. Choose AGC from the menu screen. 11-4. Use the "P " button on the remote control so that the voltage at the test point is 2.5 VDC.
C Fig.10-2
-30-
|
|
|
> |
|
