|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
 ;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
8. Use the Position Buttons to adjust each point so that the Green Crosshatch Pattern is aligned with the vertical and horizontal lines of the Convergence Adjustment Sheet. 9. Push the "MULTI PIP" and with from "G-EASY DATA" to "G-EASY CURSOR". 10. Repeat step 7~9 to adjust the 9 adjustment points.
11. Select the "G-POINT CURSOR" mode by pushing "TV/AV" button on the remote control. 12. Use the Position Buttons to move the cursor to the point where you wish to change the data (adjustment lines). Then use the "MULTI PIP" to change from "G-LINE CURSOR" to "G-LINE DATA". 13. Use the Position Buttons to adjust each point so that the Green Crosshatch Pattern is aligned with the vertical and horizontal lines of the Convergence Adjustment Sheet. 14. Push the "MULTI PIP" and switch from "G-POINT DATA" to "GPOINT CURSOR". 15. Repeat step 12-14 to adjust all of adjustment points.
54
|
|
|
> |
|
