|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
Adjusting the output level of each speaker while listening to it
1
CH LEVEL
SPEAKERS A PCM DIGITAL STEREO
Fine-tuning the output level of each speaker
You can fine-tune the output level of each speaker according to your taste.
The output levels you set as below will be lost once the unit is in stand-by mode. (The speaker levels you set using the test tone will be restored.)
db
2.3
PRESET/MODE ADJ
PUSH TO ENTER
PRESET/MODE ADJ
1. Press the CH LEVEL button. The output level of the Left front speaker is displayed. 2. Rotate the SMART SCAN CONTROLLER to select the output level and then press the SMART SCAN CONTROLLER. You can now adjust the output level of the center speaker. 3. Repeat the operation described in step 2. Set the speaker level of each speaker in the following sequence: Left (Left front) Center Right (Right front) R-sur (Right surround) L-sur (Left surround) Subwoofer (Subwoofer) You can adjust the output level of each speaker in the range of -12 to +12 dB. The adjustment range of the subwoofer is -30 to +10 dB. To use the above setting from now on...
PUSH TO ENTER
The above setting will be overwritten by the speaker output levels you set through the test tone, once you press the TEST button on the remote controller.
1
� Adjusting the output level of each speaker using the remote controller
1. Press the MODE AUDIO button. 2. Press the CH SEL button repeatedly to select the speaker whose output level you wish to fine-adjust. Each time you press the CH SEL button, the output level of the speaker displayed is changed in the following sequence: Left (Left front) Center Right (Right front) R-sur (Right surround) L-sur (Left surround) Subwoofer (Subwoofer) 3. Press the LEVEL + or - button repeatedly to fine-adjust the output level. You can adjust the output level of each speaker in the range of 12 to +12 dB. The adjustment range of the subwoofer is -30 to +10 dB.
2
3
42
|
|
|
> |
|
