|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete service manual in very good scanning quality with all schematic and PWB graphics as well as assembly & maintenance instructions. A slight drawback is that the rastering of the PWB graphics sometimes makes it a bit difficult to follow fine traces, but no showstopper.
;
Purchased the manual that I was looking for at a great price and could download it easily.. Great service experience and for future purchases I plan to use the site. Thank you very much
 ;
Service manual in good quality, it was very helpful to me. Perfect service, I am very satisfied.
Jochen Kelm
;
Exellent manual ,it was in great condition,and got all the info i expected,5 stars!!
;
I searched the Internet exhaustively for this manual and Owner-Manuals was the least expensive...but provided an excellent reproduction within 4 hours. Very satisified.
TX-DS494/HT-R490 ADJUSTMENT PROCEDURES
IDLING CURRENT ADJUSTMENT
1. Before Idling adjustment, turn the trimming resistors R573, R574, R673, R674 and R1532 to counter clockwise. 2. Connect the DC voltmeter to sockets P511,P512, P611, P612 and P1511. 3. After turn POWER to ON, adjust the trimming resistors R573, R574, R673, R674 and R1532 so that the reading of voltmeter becomes 2.4 to 2.6 mV. 4. After adjustment, attach the top cover. 5. Confirm the voltage of above points after five minutes. 6. When 3.1 mV to 6.4 mV : Readjust the trimming resistors above so that the voltage becomes 6.5 to 6.7 mV. When 6.5 mV to 7.5 mV : It is not necessary to adjust. When 7.6 mV to 13 mV : Readjust the trimming resistors above so that the voltage becomes 7.5 to 7.7 mV.
[Note] No load and No signal
Front Lch
Front Rch
P511
P512
R573
R574
Front side Front side
R1532
P612
R674
R673 P611
P1511
Center ch
Surround Rch
Surround Lch
|
|
|
> |
|
