|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Quick service response. A useful and very rare service manual with all details. I recomend this service.
;
I ordered this manual sometime in the afternoon and I received it on my e-mail the same evening.
This is a fantastically good and properly scanned copy of the original manual. All pages are of the same scale and they overlap each other. It means that you can print the manual and easily make it as a convenient paper manual.
The content of the manual is fantastic. Alignment descriptions, PCB layouts and elementary diagrams are explicit and precise. I immediately found what I was looking for. Thanks to this manual and Owner-Manuals.com my amplifier is alive again. Many thanx indded!
;
The manual was well-scanned and easy to read. As an added bonus, the Operator's Manual was bundled with the Service Manual!
I'd definitely use owner-manuals.com again.
;
Finally, i found one website, where i can download this service manual , and fix my hifi. The service manual is very good, and easy to download and to print.
TX-SR602/E ADJUSTMENT AND CONFIRMATION PROCEDURES
1.Idling current adjustment
Before Idling adjustment, turn the trimming resistors R6040 to R6045 counter-clockwise fully. Connect the DC voltmeter to sockets P6080 to P6086. After turn POWER to ON, adjust the trimming resistors R6040, R6041 and R6042 so that the reading of voltmeter becomes 1.25mV. (Front and center channels) Adjust the trimming resistors R6043, R6044,R6045 and R6046 so that the reading of voltmeter becomes 0.75 mV. (Surround and surround back channels) After adjustment, attach the top cover. Confirm the voltage of points above after about five minutes. Front and center channels When less than 5.0 mV, readjust the resistors above so that the voltage becomes 5.0 mV. When 5.0 mV to 6.0 mV, it is not necessary to adjust. When more than 6.0 mV, readjust the resistors above so that the voltage becomes 6.0 mV. Surround and surround back channels When less than 3.5 mV, readjust the resistors above so that the voltage becomes 3.5 mV. When 3.5 mV to 4.5 mV, it is not necessary to adjust. When more than 4.5 mV, readjust the resistors above so that the voltage becomes 4.5 mV. Note: No load and No signal
IDID+ ID+ ID-
COM BIAS R6040 P6080 BIAS R6041 P6081 BIAS R6042 P6082 ID+ IDBIAS R6043 P6083 BIAS ID+ IDR6044 ID+ IDSL P6003B P6084 P6004B ID+ IDTH2 P6301 TH1
L
P6000B
R
P6001B
C
P6002B
SR
NAAF-8397
NAAF-8391
BIAS R6045 SBL P6085 BIAS R6046 P6086 SBR ID+ ID-
|
|
|
> |
|
