|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
TX-SR804/804E DEBUG MODE -1
How to Check Versions of Main, DSP and Video(HDMI) Microprocessor
1. Press and hold down DISPLAY button, then press STANDBY/ON button when the unit is power ON. The main microprocessor version will be displayed on FL for 3 seconds. <Ex.>
V e r.1.01/06920a
2. Press SETUP button while the version is displayed, then " DSP Ver: " will be displayed.
DSP Ver:
3. Press ENTER button while " DSP Ver: " is displayed, then " DSP F/W Update " will be displayed.
DS P F/ W Update
4. Again, press and hold down DISPLAY button, then press STANDBY/ON button in order to get DSP version. 5. Press SETUP button a few times. The versions of DSP ROM ---> Video(HDMI) microprocessor ---> Main microprocessor will be displayed in turn. <Ex.>
DS P Ver :05Y28A HDM.Ver :06607A V e r.1 .01/06920a
<Ex.>
<Ex.>
6. To check DSP version next time, the procedures of 2-4 are not necessary until the power cord is off.
How to Set in Debug Mode
1. Press and hold down DISPLAY button, then press STANDBY button while the unit is power ON. The version number of microprocessor is displayed only for 3 seconds. <Ex.>
V er .1 .01/06920a
2. Press DISPLAY button while the version is displayed, then the status of DSP and DIR etc will be displayed. <Ex.>
E 6 A 4 8K017FF00x0
Refer to next page to see the information displayed for detail. 3. To exit, press STANDBY/ON button.
 $4.99 TX-SR804 ONKYO
Quick Start Quick start guide ( sometimes called quick guide ) contains most important information on how to use…
|
|
|
> |
|
