|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
First class Service,
best quality, come again
Thank You.
vac
;
I didn't realise a manual for an early plasma TV such as the one we were gifted could be so easily obtained. No manual was supplied with it, and as senior citizens we were a little puzzled over some aspects of its use. I do not want a listing for your store credit as we are not fairly big computer users. The manual was well organised, as it should be, with its backing of the Pioneer name. The download was prompt and everything worked quite smoothly. Thank you. Gordon.
;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
 ;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
TX-SR804/804E DEBUG MODE -1
How to Check Versions of Main, DSP and Video(HDMI) Microprocessor
1. Press and hold down DISPLAY button, then press STANDBY/ON button when the unit is power ON. The main microprocessor version will be displayed on FL for 3 seconds. <Ex.>
V e r.1.01/06920a
2. Press SETUP button while the version is displayed, then " DSP Ver: " will be displayed.
DSP Ver:
3. Press ENTER button while " DSP Ver: " is displayed, then " DSP F/W Update " will be displayed.
DS P F/ W Update
4. Again, press and hold down DISPLAY button, then press STANDBY/ON button in order to get DSP version. 5. Press SETUP button a few times. The versions of DSP ROM ---> Video(HDMI) microprocessor ---> Main microprocessor will be displayed in turn. <Ex.>
DS P Ver :05Y28A HDM.Ver :06607A V e r.1 .01/06920a
<Ex.>
<Ex.>
6. To check DSP version next time, the procedures of 2-4 are not necessary until the power cord is off.
How to Set in Debug Mode
1. Press and hold down DISPLAY button, then press STANDBY button while the unit is power ON. The version number of microprocessor is displayed only for 3 seconds. <Ex.>
V er .1 .01/06920a
2. Press DISPLAY button while the version is displayed, then the status of DSP and DIR etc will be displayed. <Ex.>
E 6 A 4 8K017FF00x0
Refer to next page to see the information displayed for detail. 3. To exit, press STANDBY/ON button.
|
|
|
> |
|
