|
There are currently no product reviews.
 ;
Excellent quality, helped to fix problem. Thank you very much!!!!
;
I thank Owner-Manuals.com for providing the necessary manual very quickly, and it was very helpful in repairing my personal Audio System and I once again thank them for the wonderful customer's service satisfaction.
Thanks.
;
Everything fine: quick service, no glitch and above all a very good quality of the Pdf file. Thank you!
;
The manual was complete, parts list, adjustment procedures, etc. No worries
 ;
Very usefully, I could find the trouble clearly with that manual.
TX-SR875 OPERATION CHECK-2
SPEAKER PROTECT-2 (CURRENT DETECTION)
[When] 1. Exchange the power transistors (Q6050 - 6056, Q6060 - 6066, Q6080 - 6086, Q6090 - 6096). 2. Exchange the amplifier PC board ass'y (NAAMP-9061, 9062, NACLA-9063 - 9069). [Procedure] <Note> No input. Do not check two or more channels at the same time. Do not connect a dummy load to speaker terminal longer than 2 seconds. 1. Press and hold down CD button, then press STANDBY/ON button while the unit is powered on. " Test - _ "is displayed only for 5 seconds.
Te st - _
Blinks
2. Press GAME/TV button, while " Test - _ " is displayed. The unit will be in the state of " Test-4-00 ".
Te st - 4- 00
3. Repeatedly press TONE + button until " Test-4-36 " is displayed.
Te st - 4- 36
4. Connect the dummy load of 3 ohms to the Front L ch speaker terminal. At this time, confirm that the speaker relay is not turned off.
Te st - 4- 36
5. Connect the dummy load of 1 ohm to the Front L ch speaker terminal. At this time, confirm that the speaker relay is turned off and " Protect " is displayed.
P r otect
Disconnect the dummy load immediately after checking the display of " Protect ".
Te st - 4- 36
6. Check other channels according to the same procedure as 4 and 5. Front R, Center, Surround L, Surround R, Surround Back L, Surroun R 7. Press STANDBY/ON button.
Turn off
Clear
|
