|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
;
I was impressed with the quality of service (frequent e-mails to let you know the status of your order), and the speed at which the download became available. The manual was a life saver and was not easy to track down. Thank you for such an excellent service.
;
the manual was just what i wanted it had all the revelent information required to operate the hifi .Iwould use any manual i downloaded for any item which needs a manual
;
Die gewünschte Bedienungsanleitung wurde vereinbarungsgemäß in deutsch bereitgestellt. Sie ist gut lesbar. Kein Kauderwelsch.
Danke für den Service.
;
GOOD SERVICE MANUAL GOT ALL THE INFO. THAT I NEEDED..
Connecting antennas
Antenna cables
1
2
3
1. Press down the lever. 2. Insert the wire into the hole. 3. Release the lever to replace it.
AM loop antenna
Assemble the loop antenna as shown in the illustration. (Refer to the next page for details on connecting the AM loop antenna.)
Insert into the slot.
75/300 ohm antenna adapter (worldwide and some other models)
Outdoor FM/TV antenna Indoor T-shaped antenna
300 ohm ribbon wire
Connecting the T-shaped antenna or 300 ohm ribbon wire to the 75/300 ohm antenna adapter: Loosen the screws and wrap the wires around them. Then, tighten the screws with a screwdriver.
1
2
Slit B
3
3 3 33 3 3 3 33 3 3
Connecting the coaxial cable to the 75/300 ohm antenna adapter: 1. With your �ngernail or a small screwdriver, pull the stoppers outward and remove the cover. 2. Remove the transformer wire A from slit B and insert it into slit C. 3. Prepare the coaxial cable as shown in the diagram. Connect the coaxial cable to the 75/300 ohm antenna adapter. 1 Insert the end of the cable. 2 Clamp it in place with pliers. 4. Re-install the cover.
636 mm mm mm
15mm
Wire A Slit C
1
2
Directional linkage
Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter.
Directional linkage type splitter To TX-SV373/TX-SE350 To TV (or VCR)
12
|
|
|
> |
|
