|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
;
Good,readable manual. I found other manuals that were not readable when it came to part ID, but the one downloaded from owner-manual.com was better than expected. I will do buisness with owner-manual.com again.
;
Service Manual that I received was very helpful to me. Thank you.
;
The manual is well organized and is easy to read. The chapters are following normal way to proceed.
;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
It should be clear that the base of Q520 should not be more than -1 2vdc and Q518 +1 3vdc Q516 is -1.2vdc +1.3vdc. the bias and its turn on is the potential difference of RC components R540 and R538. Q518 also gets its controlled DC via Q526 A t ll d i Q526. Assuming th t th voltage amplifier i working correctly, th th amount of i that the lt lifi is ki tl then the tf voltage delivered at the base of Q520 and Q518 should be within the tolerance to be g g governed (controlled) by Q516. In general practice two possibilities exist in this case case. 1. The base drive voltage coming from Voltage amplifier stage arriving at Q518 and Q520 is to high to be controlled by Q516 and its associated components. 2. Q516 and its associated switching + RC and Voltage divider R-Nets are failing. Q526, C538, D506, R Nets D504, R562, are all part of the Q516 operators service as reference control to the bias. Is the problem 1 or 2 or both?
|
|
|
> |
|
