|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was magic after so many years to still be able to source this info. It was equally amazing to return my Pioneer receiver to it near new sound quality AFTER NEARLY 30 YEARS! Thank you for this ability!
;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
 ;
Easy and secure way to get a complete service manual of a vintage hifi component. Only some parts of the print copy are dificult to read. Nice price!
;
The manual is an excellent reproduction with complete schematics, made troubleshooting and repair a simple process.
;
Up to now you are the BEST! Prompt-efficient and so reasonable ! I have been after SONY service manual for quite some time !Thank you very much ! I can recomend your service to
all my collegagues ! V.Bergfield .
2.1
Warnings � Insulating test
Warnings
ESD STATIC ELECTRICITY MAY DESTROY THE PRODUCT
When electrical replacements or disassembly is taking place, use an ESD-mat. The internal electronics are very sensitive to static electricity. Handling Wear cotton gloves to avoid any �ngerprints on the product. The surfaces on the product are very sensitive, so handling should be done with great care to avoid damage. Cleaning of the speaker surfaces should only be done with a lint-free cloth which you have dipped in lukewarm water and wrung �rmly.
Insulation test
The product must be insulation tested after having been dismantled. Make the test when the set has been reassembled and is ready to be returned to the customer. Flashover must not occur during the test. Make the insulation test as follows: Short-circuit the two pins of the mains plug and connect them to one of the terminals of the insulation tester. Connect the other terminal to ground on the Power Link socket. NOTE! To avoid damaging the product it is essential that both terminals of the insulation tester have good contact. During the test the current must not exceed 5 mA. Slowly increase the voltage on the insulation tester until a voltage of 2.5 kV (ac) is obtained. Maintain the voltage level for one second, then slowly decrease the voltage to 0 V (ac).
|
|
|
> |
|
