|
Who's Online
There currently are 5840 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
9.25
Einstellungen, Deutsch
Geometrieeinstellungen im Format 2 (16:9)
Es müssen nur die beschriebenen Einstellungen erfolgen. TV-Gerät einschalten. DISPLAY-Taste ca. 3 Sekunden drücken. n drücken, bis FORMAT angezeigt wird, dann GO. Mit m FORMAT 2 wählen. Servicemodus aktivieren und MONITOR wählen. GEOMETRY ADJUSTMENTS wählen. Bei der Wahl einer Einstellmöglichkeit muss sich das Bildformat in 16:9 ändern.
Vertikalamplitude (V-AM) - V-AM für richtige Bildgrö�e am oberen Bildschirmrand einstellen. Vertikal�anke (V-SL) - V-SL für einen Abstand des Kreisunterrands von ca. 10 cm zum unteren Rand des sichtbaren Bilds einstellen. Horizontalamplitude (H-AM) - H-AM für richtige Bildbreite einstellen. Vertikalverschiebung/Zentrierung (V-SH) - V-SH für einen Abstand des Kreisoberrands von ca. 8 mm zum oberen Rand des sichtbaren Bilds einstellen. Ost/West-Parabeleinstellung (EW-P) - EW-P für richtige Bildgeometrie an den Seiten einstellen. Die Mitte der vertikalen Linien muss so gerade wie möglich sein. Ost/West-Einstellung obere Bildecken (EWUC) - EWUC für richtige Bildgeometrie an den oberen Bildecken einstellen. Ost/West-Trapezeinstellung (EW-T) - EW-T für richtige Bildgeometrie einstellen. Horizontalparallelogramm (H-PA) - H-PA für richtige Bildgeometrie einstellen. Einige dieser Einstellungen müssen ggf. wiederholt werden. - GO drücken, um die Einstellungen zu speichern. Servicemodus verlassen.
Für andere Einstellungen siehe Kapitel 5.
|
|
|
> |
|