|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
a solid deal - quick and without any problems.
I life in europe - with downloads no loosing time
once again
 ;
got exactly what i ordered in a very timely manner. will use again for other manuals
;
I'm happy. Good quality. Very helped me with my work..............................
;
This is the second Manual I have ordered from owner-manuals, I give it five stars because it is exactly what I expected given the age of the equipment. So the contents look a bit aged and the pictures a bit grainy, it fulfills my needs and I am glad I can still get hold of them.
;
thank u so much for this manual that was so cheap that i thought it was a scam but i gambled anyway because it was too good of a deal to pass up and behold,the manual has everything and details of everything even the screws and im still amazed and very happy with my manual .so take my word and jump on it before they realize how cheap they selling thier manuals..thank you so much for taking time to read my thoughts
Final check after repair
3.7
Final check after repair
Final check after repair The �nal check after repair, describes the activities that are needed to ensure the product will be returned in perfect condition to the customer. The contents is: AC leakage test. Check product information. Restore the setup and check connections, picture and sound. Final cleaning of the product. PIN-code setting.
AC leakage test
The scope of the test is, to check the antenna terminals and other exposed metal parts for AC leakage. 1. 2. 3. 4. Remove the line cable from the AC source (the wall outlet). Place a jumper across the two AC plugs prongs. Use a multi-meter, set for measurements in the ohm-area. Place one lead from the multi-meter on the AC plug and place the other lead on each of the exposed metal parts, that is antenna connections and other exposed metal parts on the rear panel of the product. The resistance during these measurements must be of 1 Mega Ohm or more. If resistance is below 1 Mega Ohm, this indicates an abnormal situation and corrective actions must be taken.
5.
Insulation test Each set must be insulation tested after having been dismantled. Make the test when the set has been reassembled and is ready to be returned to the customer. Flashovers must not occur during the testing procedure! Make the insulation test as follows: Short-circuit the two pins of the mains plug and connect them to one of the terminals of the insulation tester. Connect the other terminal to ground on the aerial socket. NOTE! To avoid damaging the set it is essential that both terminals of the insulation tester have good contact. Slowly turn the voltage control of the insulation tester until a voltage of 1.5 kV and max. 10mA is obtained. Maintain that voltage for one second, then slowly turn it down again. Insulation test at the customer Remove the mains cable from the wall outlet. Place a jumper across the two AC plug prongs. Use a multi-meter, set for measurements in the Ohm-area. Place one lead from the multi-meter on the AC plug and place the other lead on ground at the Power Link plug. The resistance during this measurement must be of 1 Mega Ohm or more. Resistance measured below 1 Mega Ohm indicates an abnormal situation and corrective action must be taken.
|
|
|
> |
|
