The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Text excerpt from page 32 (click to view)
THINGS TO NOTE
· · · · · · ·
This appliance is designed to be fitted between cabinets with the recommended dimensions as shown in Fig. 3 & 4. If there is an existing housing unit it must be removed. The dimensions given provide adequate air circulation around the unit within the cabinet, ensuring compliance with BS EN60-335. This appliance must not be installed on a wooden base board. Enquiries regarding the installation of the cooker point, if required, should be made to your Regional Electricity Company to ensure compliance with their regulations. The cooker point should be within 2m of the appliance to make it accessible to switch off the appliance in case of an emergency. To protect the hands, wear gloves when lifting the oven into its housing. Do not lift the appliance by the handles. Fig. 4 Fig. 3
NOTE: HOUSE CIRCUIT Earth leakage / continuity tests must be carried out before the appliance is connected to the mains supply and re-checked after fitting.
PREPARING CABINET FOR FITTING OVEN
· · · · · · ·
Make sure the space between the cabinets is the correct size for the appliance to be fitted (Ref. Fig. 5 & 6). The plinth board spanning the space into which the appliance is to be installed should be removed. If the size between adjacent cabinets is 605610mm, then the cabinets should be modified so that the recommended dimension of at least 600605mm is maintained. The adjacent cabinets must be stable and firmly secured to the wall or floor. If necessary, make arrangements to ensure the work surface below which the oven will rest is level. Drill two pilot screw holes into the sides of the adjacent cabinets, in the positions indicated by Fig. 5. Fit the appliance mounting brackets using the two holes indicated in Fig.7 to the adjacent cabinets (Ref. Fig.5 & 6). Check that the mounting brackets are level. They can be adjusted if necessary by using the extra holes at the ends of the brackets. Once the brackets are level, drill a pilot hole through the central hole in the bracket and fit the remaining screw. Fig. 6 Fig. 5
