|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
;
Bought the used Philips car-radio. No manual! Found on this site a copy of the orginal English manual. I am very happy with it. Now I know how to setup and use my "new" car-radio.
Recommended site for everybody looking for a manual for (older) products!
System settings
Restoring the factory settings (Factory Reset)
This operation will restore the following items set from UA-101 Control Panel to their factory-set state. � Direct monitor mixer (p. 39) � Patch bay (p. 40) � Memory (p. 40)
1 2
fig.system.eps
Disconnect the USB cable from the UA-101. Turn the power switch all the way toward the left to the STANDBY position.
Press
3
Press the digital input switch, STEREO/ MONO select switch, and direct monitor soft control switch to turn them all on ( pressed inward). Set the sample rate switch to 192 kHz.
192kHz
4 5
fig.system-2.eps
Turn the power switch toward the right to turn on the power. The sync indicator will light, then immediately go out.
ON
6
Within three seconds, turn the sample rate select switch to 96 kHz. Then, immediately turn it back to 192 kHz. * You must perform these operations no longer than three seconds apart from each other.
96kHz
fig.system-3.eps
192kHz
7
The input/output level indicators will blink, and the UA-101 will be reset to its factory-set state. Turn the UA-101 off, then on again.
45
|
|
|
> |
|
|
Parse Time: 0.275 - Number of Queries: 132 - Query Time: 0.085
