|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was of good quality with high resolution schematic diagrams.
;
The manual was very clear and contained all the information I was looking for. My dishwasher is working again because of this servicemanual!
;
Quality scan, great manual. I solved my problem with this manual.
 ;
The AKAI 1720 model reel to reel tape recorder described in this Manual is quite an old unit - circa late 1960's. As a consequence, the description of the mechanical details - and adjustments thereof - is quite critical. The manual does this quite well. The schematics are also well presented and have detailed PCB overlays. Probably the only negative is that some half-tone detail has been lost from the original manual as it has been scanned in simple B&W.
;
Perfect source for service manuals: fast and professional transaction; high quality, perfect readable and largely scaleable PDF; complete schemes, diagrams and spare part list. Tnx a lot, cu again!!!!
1-9. System File Recovery
Installation (Update) 1. Remove the six screws, then open the upper panel. n Do not disconnect the flexible flat cable connecting the PS-635 board and the MB-978 board. 2. Check that S201 (D-1) on the MB-798 board is set to ON. 3. Insert the boot-up MMC to the CN201 (D-1) on the MB-978 board. 4. Close the upper panel. (Securing with screws is not required.) 5. Turn on the power of the UCP-8060. 6. While pressing the function button 2, press the select L and R buttons simultaneously for more than three seconds. When the function button 2 lights on, release all buttons. 7. Insert the Memory Stick in which the system file is written into the Memory Stick slot of the UCP-8060. 8. Press the select R button according to the instruction on the screen. Updating of the system file starts. 9. Check that the message to indicate the completion of updating is displayed on the screen. 10. Pull out the Memory Stick from the Memory Stick slot. 11. Turn off the power of the UCP-8060. 12. Open the upper panel and pull out the boot-up MMC. 13. Close the upper panel. Operation check 1. Turn on the power of the UCP-8060. 2. Check that the Main screen is displayed. If the Main screen is displayed, it means that the system file is recovered. n In case that the Main screen is not displayed, the hardware may be damaged. Refer to �Although the back light is lit, nothing is displayed on the liquid crystal panel� in �1-4. Troubleshooting�. 3. Attach the upper panel with the six screws. 4. Install the operation software as required. (Refer to the operation manual.)
UCP-8060
1-17 (E)
|
|
|
> |
|
