|
Who's Online
There currently are 5959 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
VERY GOOD SERVICE.FAST ANS VERY HONEST PRICE .RHAANK HERNAN
;
Thanks to this service manual I repaired my old camcorder! The manual perfectly explains how to disassemble the camcorder step by step.
;
This manual is very useful because it presents the technical specifications of the cd player, including the manufacturer of the reader, this helps if you need to replace it. It also displays the settings and layout of the circuit.
;
Manual was a good representation of service infomation for the EWV404. It worked well for my repair.
;
Great quality copy, right what I was looking for, all I need to fix my radio.
Thanks
CHAPTER 3. SERVICE PRECAUTION
1. IPL (Initial Program Loading) FUNCTION
1) INTRODUCTION
The application software of the UP-600/700 written in the flash ROM. In the following cases, writing procedure of the application software into the flash ROM is required 4. Turn on the power switch of the UP-600/700. 5. The following display is shown and the IPL procedure is started. When the procedure is completed, the message of "Completed" is shown.
� When the flash ROM is replaced with new one. The service part
flash ROM does not include the application software in it.
IPL from PROM Version check� Erase �
� When IPL writing is required because of change in the software.
The service part ofthe main PWB unit includes the flash ROM with the application software written in it, and there is no need for writing the application software when replacing the main PWB unit.
2) IPL PROCEDURE
There are two ways of IPL procedures.
� IPL from P-ROM � IPL from PC communication (Please refer the next section)
The detailed descriptions on the above procedures are given below.
26 27 28 29 2A 2B 2C 2D 2E 2F 30 31
IPL write start
3) IPL FROM P-ROM
Master ROM-1 : VHI27801RAP1A Master ROM-2 : VHI27801RAQ1A Before working on the installation, turn off the power switch on the UP-600/700 and unplug the AC code from the AC outlet. 1. Insert a screwdriver into the slit on the right side of the lower cabinet to remove the option RAM case.
32 33 34 35 36 37 38 39 3A 3B 3C 3D 3E 3F Verify � Completed. IPL write completed
6. Turn off the power switch of UP-600/700. 7. Remove to the IC sockets on the IPL ROM PWB. 8. IPL switch (SW301) on the IPL ROM PWB: Set the IPL switch (SW301) to OFF position. 9. Perform the master reset.
2. IPL switch (SW301) on the IPL ROM PWB: Set the IPL switch (SW301) to ON position. 3. Install to the IC sockets on the IPL ROM PWB.
ROM1 ROM2
ROM1
on off
ROM2
SW301
|
|
|
> |
|