|
There are currently no product reviews.
 ;
Excellent printing quality. A complete and very useful manual with all details.
;
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
;
Very good quality original datasheet!I like this amazing website!!!!!!
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
5-2. Print is Too Dark or Too Light
START
Is reference voltage input to pin 2 of IC6 on MA-99 board when �CONTRAST� is set to center position? YES
NO
Peripheral circuits Q200 and Q16 on MA-99 board are defective.
Is reference voltage input to pin 5 of Q7 on MA-99 board when �BRIGHT� is set to center position? YES NO
Peripheral circuits Q16 and RV6 on MA-99 board are defective.
Is voltage (approx. 1.5 to 2.5 V) available at pin 6 of IC304 on MA-99 board when head is at the normal temperature? YES
Peripheral circuit IC401 and pins 29 and 30 of CN9 NO on MA-99 board, or the thermistor in the head are defective.
Are required voltages available at each terminal, 3 V at pin 19 of IC500 on MA-99 board, and 1 V at pin 23 of IC500? YES
Peripheral circuit Q21 on MA-99 board is defective. NO
The head voltage or CN9 on MA-99 board is defective. Is density of stair step printed in test mode properly? NO
YES
The data buses of IC500 and IC503 on MA-99 board are defective.
5-2
UP-895/(E)
|
