|
Who's Online
There currently are 5959 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
Wiring Diagram page 5 /8
#299 1) Insert the RED tape side of "ECN" in the T-com board. 2) �ECN" must pass on �ELCD3�. *Refer to photo 1 (page3/4) Do the styling so that the wire After dressing �EPS" and �ELCD3�, stick the tape (#299 Nitto tape) on them. Refer to the Final Assy Guide Page 5/9. should not pass the upper part of ELCD3 EPS the shielding case.
D8MW
Do the styling so that the binding tape of �ELCD3� should not pass over the
frame. (Prevent it from touching with the back-cover.)
#299
#SKUL
#SKUL
Insert it surely.
#SKUL ELCD ELCD2
#361
ECN EPS
UT32S402 UT32S602, UT32V502, UT32V502W, UT32X812, ONLY.
12pin
#360 EFF
Detail-1(page2/4) Photo2(page3/4)
ELS NSPK
EISP
NSP EKL EISP EPU #NSP
EISP NEL E001
E002
The wire of �EKL" must go in between the KEY_SW
Photo 4 (page3/4)
IR/POW SW board
Detail-2
(page2/4)
board and the case, the surplus is hold in between. (It is to prevent the electric wire being pinched when tightening up a screw.) *Refer to photo3(page3/4)
Fix with SK binder(#NSPK) so that the wire of �EISP" should not touch the filter board. *Refer to photo5 (page 4/4)
TABLE OF CONTENTS
40
|
|
|
> |
|