|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I didn't realise a manual for an early plasma TV such as the one we were gifted could be so easily obtained. No manual was supplied with it, and as senior citizens we were a little puzzled over some aspects of its use. I do not want a listing for your store credit as we are not fairly big computer users. The manual was well organised, as it should be, with its backing of the Pioneer name. The download was prompt and everything worked quite smoothly. Thank you. Gordon.
;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
 ;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
;
Service manual very complete and clear. It was very helpfull for my work.
4Remove the used film from the cartridge.
9Cut the band that holds the two spools together. Unroll the film slightly
and insert the small gears into their holders.
UX-385DE/H/GG/IT/ES FO-785DE/IT/ES/NX-575IT
5Remove the four green gears from the used film.
DO NOT DISCARD THE FOUR GREEN GEARS!
FTurn the cartridge over, grasp the handle, and insert the cartridge
into the print compartment.
6Remove the new roll of imaging film from its packaging.
� Do not yet remove the band that holds the rolls together.
GRotate the large gear toward you until the film is taut.
7Insert the large gear into the green end of the empty spool. Make
sure the two protrusions on the large gear fit firmly into the slots in the end of the spool. Insert the remaining three gears into the spools, making sure the protrusion on each gear fits firmly into one of the slots in the end of each spool. � If needed, pull the spools apart slightly to allow the gears to fit (the band will stretch).
Protrusion Slot
HClose the print compartment cover (press down on both sides to make
sure it clicks into place), and then close the operation panel.
Click!
Large gear
ILoad paper in the paper tray and then press the following keys to
Note: Paper must be loaded before the film can be initialized. To load paper, see the following section, Loading Printing Paper.
FUNCTION
Display shows:
8Insert the large gear into the large holder on the imaging film cartridge
(make sure it clicks into place), and then insert the small gear on the other end of the spool into its holder.
initialize the film.
6
INITIALIZE FILM
START/MEMORY
When to replace the imaging film Replace the imaging film when the display shows: FILM END Use the following imaging film, which is available from your dealer or retailer: Sharp UX-3CR/FO-3CR Imaging Film
1�5
 $4.99 UX385 SHARP
Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|
