SHARP UX-68
Service Manual

UX-68ES/F/GG/IT FO-90IT 4. Loading the fax paper (FO-20PR6)
� � Your fax machine prints incoming faxes on a special kind of paper called fax paper. The fax machine�s print head creates text and images by applying heat to the fax paper.

5 Insert the leading edge of the paperuntil the slot asout the opening in into shown. Continue to push the paper through the slot it comes
the front of the machine.

1Grasp the finger hold as shown and pull up to open the operation
panel.

6 Make sure the paper comes out straight, and then flip down the paper guide.

2Flip up the front paper guide.
UX-68

UX-68
FO-90

FO-90

3If you are loading paper that is 210mm in width, place the paper roll shims
� The ribbed side of the shims should face in (toward each other).

Press the knob to make sure the front side of the metal guide is down.

on each side of the paper compartment. (Note that Sharp recommended paper, including the initial roll, is 216mm in width.)

7 Close the operation panel, making sure it clicks into place. 4 Unwrap the roll of thermal paper and place it in the compartment.
YES NO!

� A short length of the paper will be cut off. (FO-90) � A short length of the paper will feed out. Grasp the paper by the edge and pull upward to tear it off. (UX-68)

� Important: The roll must be placed so the leading edge of the paper unrolls as shown. (The paper is only coated on one side for printing. If the roll is placed incorrectly, the paper will come out blank after printing.)

Click!

1�6