This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
Fast and courteous service. Product delivered as described. Thank you.
Text excerpt from page 15 (click to view)
Adjusting the Tone
You can adjust the bass level (low frequency range) and the treble level (high frequency range) within a range of ��5� to �+5.� When shipped, each level is set to �+2.� � This function also affects the sound from headphones. � This function only affects the playback sound, and does not affect your recording. � There is a time limit in doing the following steps. If the setting is canceled before you finish, start again from step 1.
Changing the Display Brightness
You can change the display brightness only while the unit is turned on.
On the remote control ONLY:
Press DIMMER while the unit is turned on. � Each time you press the button, the display brightness changes as follows: DIMMER 1: « DIMMER 2: The display illumination dims. The display illumination dims and the blue illumination on the display disappears.
DIMMER
On the remote control:
1 Press BASS to adjust the bass level or
press TREBLE to adjust the treble level.
Current setting
BASS
«
TREBLE
DIMMER OFF: The display and blue illumination resumes. « (back to the beginning)
Ex.: When you select �BASS.�
2 Press
DISC UP to increase the level or press DISC DOWN to decrease the level.
DISC UP
Turning off the unit (standby) sets the display brightness back to �DIMMER OFF.�
DISC DOWN
On the unit:
1 Press BASS to adjust the bass
level or press TREBLE to adjust the treble level.
TREBLE
BASS
2 Press ¢ UP to increase
the level or press 4 DOWN to decrease the level.
