|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
3.1.9 Removing the heat sink/power board (See Fig.20 to 27) � Prior to performing the following procedure, remove the front panel assembly. (1) From the bottom of the rear cover, peel off the tape attaching the wire extending from the power board and remove the earth plate which is attached with the double-sided tape. (2) Remove the four screws T attaching the holder in the power unit section. (3) Move the power unit section with the wire from the rear cover temporarily. If necessary, release the band and unsolder the wire on the power board. (4) Remove the four screws U and the screw Y attaching the holder. (5) Release the wire from the band at �e� and move the holder in the direction of the arrow to release from the joint f. (6) Remove the four screws A� and two screws B� attaching the heat sink. (7) Remove the two screws D� attaching the power board.
Power unit section
T
T
T
T
Power unit section
Rear cover Power trnsfomer assembly
Fig.21
Wire
Rear cover Tape
Fig.20
earth plate
Rear cover Ppwer unit section
Fig.22
(No.MB297)1-15
 $4.99 UX-H330 JVC
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|
