|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
English
AM antenna
Connecting Speakers
]
]
1
2
3
ANTENNA
1
AM EXT AM LOOP
Vinyl-covered wire (not supplied)
RIGHT LEFT
Red Speaker cord
MAIN SPEAKERS
Speaker cord
FM 75 COAXIAL
SPEAKER IMPEDANCE MIN 4
Black
2
AM loop antenna (supplied) Right speaker Left speaker
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
� If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram.
1 Press and hold the clamp of the speaker
terminal on the rear of the unit.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)
2 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red (+) and black (�) to black (�).
3 Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.
For better reception of both FM and AM � Make sure the antenna conductors do not touch any other terminals and connecting cords. � Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.
�7�
|
|
|
> |
|
