|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
;
Thank you, this is a rare document. Few others have it, but they charge way more for a download.
Great deal (even if you have to wait a few hours to get it).
;
The purchased manual is an high quality scan of the original Philips paper-based Service Manual. I am very satisfied!
 ;
The purchased manual is an scan of the original Panasonic paper-based Service Manual. Unfortunately the contrast is not perfect, but I am satisfied anyway!
UX-T77 <<Cassette mechanism section>>
Cassette mechanism Removing the Playback/Recording & Eraser Head (See Fig. 1 to 3) 1. While shifting the trigger arms seen on the right side of the head mount in the arrow direction, turn the flywheel R in counterclockwise direction until the head mount has gone out with a click (See Fig. 1). 2. When the flywheel R is rotated in counterclockwise direction, the Playback/Recording & Eraser head will be turned in counterclockwise direction from the position in Fig. 2 to that in Fig. 3. 3. At this position, disconnect the flexible P.C. board (outgoing from the Playback/Recording & Eraser head) from the connector CN31 on the head amplifier & mechanism control P.C. board. 4. After dismounting the FPC holder, remove the flexible P.C. board. 5. Remove the flexible P.C. board from the chassis base. 6. Remove the spring 1 from behind the Playback/Recording & Eraser head. 7. Loosen the reversing azimuth screw retaining the Playback /Recording & Eraser head. 8. Take out the Playback/Recording & Eraser head from the front of the head mount. 9. The Playback/Recoring & Eraser head should also be removed similarly according to Steps 1 to 8 above.
Flywheel R
Head mount
Trigger arm
Fig. 1
Playback/Recording & eraser head Flexible board Spring 1 Trigger arm
CN31 Reassembling the Playback/Recording & Eraser head (See Fig.3) 1. Reassemble the playback head from the front of the head mount to the position as shown in Fig. 3. 2. Fix the reversing azimuth screw. 3. Set the spring 1 from behind the Playback/Recording & Eraser head. 4. Attach the flexible P.C. board to the chassis base, and fix it with the FPC holder as shown in Fig. 3. 5. The Playback/Recording & Eraser head should also be reassembled similarly to Step 1 to 4 above. Head amplifier & mechanism control P.C. board Flywheel R
Fig. 2
Playback/Recording & eraser head Reversing azimuth screw
Spring 1
Head mount Flexible board
CN31 FPC holder Head amplifier & mechanism control
Fig. 3
P.C. board
1-12
|
|
|
> |
|
