|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is immaculate in it's accuracy. Everything is written very clearly and easy to understand. Written by a professional who wants to convey a clear and easy to understand message!!
;
This Manual (as downloaded) is both informative and comprehensive and has proved to be extremely useful. thoroughly recommended.
;
everything is ok, thank you very much! Product is good, no problems with download!
;
Great site, I always find all the manuals I need and i can't find anywhere else. PDF for the Sony PCM 3348 is complete and scan is good quality. Thank you!
;
It was a complete manual as stated. Very good source for older product manuals. Thanks
4 Press the UP, DOWN, >, or < button within 5 seconds to select the preset number.
UP or > button: Increases the preset number by 1. DOWN or < button: Decreases the preset number by 1. � When the > or < button is held down, the preset number changes rapidly.
Changing the FM Reception Mode
When you have tuned into an FM stereo broadcast, the STEREO indicator lights up and you can hear stereo effects. If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose any stereo effect.
5 Press the SET button within 5 seconds.
�STORED� appears and after 2 seconds, the display returns to the broadcast frequency display.
6 Repeat above steps 1 to 5 for each station you want to store in memory with a preset number.
To change the preset stations, repeat the same steps as above.
Press the FM MODE button on the Remote Control so that the MONO indicator lights up on the display.
FM MODE
Presetting stations automatically ���
In each band, you can automatically preset 30 FM and 15 AM (MW/LW) stations. Preset numbers will be allocated as stations are found, starting from the lowest frequency and moving up the frequency.
FM/AM AUTO PRESET
STEREO MONO To restore the stereo effect, press the FM MODE button on the Remote Control so that the MONO indicator goes off.
(For more than 2 seconds)
1 Select a band by pressing the FM/AM button. 2 Press the AUTO PRESET button on the Remote Control for more than 2 seconds. 3 Repeat steps 1 � 2 for the other band.
s If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers. CAUTION: Even if the system is unplugged or if a power failure occurs, the preset stations will be stored for about 24 hours. However, in case the preset stations are erased, you will need to preset the stations again.
9
EN01-09.UX-V100[B]f
9
12/12/00, 12:35 PM
|
|
|
> |
|
