|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great site. I placed my order and by the next am it was available for download. Had some problems with some missing copy on some pages. Once I brought the error to the OMC's attention, the issue was resolved. I'll come back again.
 ;
Mi spiace per non poter scrivere in inglese... ma sono veramente soddisfatto del servizio offerto. Grazie..!!
;
The quality of this manual is good. It has all schematics and setup information for both the MDS-B3 and the MDS-B4. The scan quality is quite good, all pages are readable, This service manual also contains scans of the operating instructions from the User manual.
;
Quick site processing. A complete and very useful manual with all details. Thank you!
;
Das Service Manual war von der ersten bis zur letzten Seite sehr informativ und hilfreich. Die Darstellung aller Teile war klar und der Text gut lesbar.
Vielen Dank, das war nicht der letzte Download bei ownner-manuals.com.
UX-V30
Removing the cassette assembly (See Fig.5 and 6)
mechanism
Cassette mechanism assembly Joint a
Prior to performing the following procedure, remove the rear cover and the side panels. 1. Disconnect the card wires from connector CN304 and CN305 on the main board on the left side of the body. 2. Disconnect the harness from connector CN309 on the Opt, Dig.out board on the right side of the body. Cut off the band fixing the harness. 3. Remove the two screws C attaching the cassette mechanism assembly on both sides of the body and release the two joints a. 4. Remove the cassette mechanism assembly in the direction of the arrow.
C
CN304
CN305
Main board
Fig.5
Cassette mechanism assembly Joint a Opt, Dig.out board
C
Band CN309
Removing the main board / the heat sink (See Fig.7 to 9)
Prior to performing the following procedure, remove the rear cover, the side panels and the cassette mechanism assembly. 1. Disconnect the card wire from connector CN303 and the harness from CN306 and CN307 on the main board respectively. 2. Disconnect the harness from connector CN902 on the power transformer. 3. Remove the screw E attaching the main board on the right side of the body. 4. Remove the screw F and the two screws G attaching the heat sink on the back of the body. ATTENTION: The heat sink can be removed even if the main board is attached to the body. 5. Disconnect connector CN301 and CN302 on the main board from the main body. Remove the main board upward by releasing the two joints b in the lower part of the main board.
CN302 Joint b
Fig.6
CN303 Transformer board CN902 CN307 Main board
Heat sink CN306
Fig.7
Main board
CN301 Joint b
E
Fig.8
1-5
 $4.99 UX-V30 JVC
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|
Home
