JVC UX-V6VU
Owner's Manual

English

s Press the KARAOKE MODE/MPX button on 4.
the Unit to select the Karaoke mode you want to use.
Each time you press the button, Karaoke mode changes as follows. Lch MONO = Rch MONO = V.REPLACE = V.MASKING = NORMAL = (back to the beginning) Lch MONO: Only the left channel (instrumental parts) are played through both speakers. Rch MONO: Only the right channel (vocal parts) are played through both speakers. V.REPLACE: Your voice replaces the right channel (vocal parts) when you sing into the microphone. V.MASKING: This has no effect for a multiplex CD and will be used for an audio CD. (See page 22.) NORMAL: Cancels the Karaoke mode. � You can also select Karaoke mode during playback.

s Within five seconds, press the UP or DOWN 2.
button on the Remote Control to adjust the key level.
KEY CONTROL
DOWN
VCD NUMBER VCD NUMBER

You can adjust the key level between �KEY �6� and �KEY +6�.

UP

�

The key setting will also appear on the TV screen in the graphical form. Display on the TV screen: �KEY I - - - - - - � - - - - - - i�

s Press the KEY CONTROL button again or 3.
wait until the key level disappears.
To return to the normal key level, repeat above steps and set the key level to �KEY 0�. Notes: � You cannot adjust the music key during recording. � Once the music key is adjusted, the key level will not return to the normal level (�KEY 0�) until your reset it to �KEY 0�, change the source, or turn off the power.

s Play a multiplex Karaoke CD. 5.
To play a video CD with the PBC function, see page 13.

s Adjust the main volume and the MIC LEVEL 6.
control as you sing into the microphone.
If you want to record on a tape, carry out CD Direct Recording or One Track Recording. (See page 18.) To cancel the Karaoke mode, press the KARAOKE MODE/MPX button until �NORMAL� appears on the display. Notes: � After finishing singing along, always cancel the Karaoke mode. Karaoke mode will be also cancelled if you change the function or turn off the power. � If �howling� occurs, keep the microphone away from the speakers. � When digital recording is made to an external equipment through the OPTICAL DIGITAL OUT terminal using an audio CD, the microphone sound is not recorded. �

Microphone Mixing
Using a microphone, you can mix the microphone sound with a source sound.

s Set MIC LEVEL control to MIN by turning it 1.
fully counterclockwise.

s Connect a microphone (not supplied) by 2.
plugging it into the MIC 1 and/or 2 jack.

s Start a source: CD, tape, tuner, or other 3.
equipment.

Applying Echo to Your Voice ���
You can apply echo to your voice through the microphone(s) except when you select the Tuner as a source. Press the DIGITAL ECHO button on the Remote Control until �ECHO ON� appears on the display. Each time you press the button, echo turns on and off, and �ECHO ON� and �ECHO OFF� appear for three seconds.
DIGITAL ECHO

s Adjust the main volume and the MIC LEVEL 4.
control, as you sing into the microphone.
� You can apply echo to your voice except when you select Tuner as a source. To apply the echo, press the DIGITAL ECHO button on the Remote Control until �ECHO ON� appears on the display. To cancel the echo, press the same button again. �ECHO OFF� will appear on the display. Selecting the Tuner or turning off the power will also cancel the echo.

Note: If �howling� occurs, keep the microphone away from the speakers.

To cancel the echo, press the DIGITAL ECHO button again until �ECHO OFF� appears on the display. Selecting the Tuner or turning off the power will also cancel the echo. Note: During recording, you cannot switch the echo.

To Record Microphone Mixing on a Tape

s Follow the above steps 1-4. 1. s To record, follow the steps in �Standard 2.
Recording�. (See page 17.)
Note: When digital recording is made to an external equipment through the OPTICAL DIGITAL OUT terminal using an audio CD, the microphone sound is not recorded.

Adjusting the Music Key ������
During playback a CD or in Stop mode, you can adjust the music key level between �6 and +6. (0: Normal key) You can use this function for only CDs.

s Press the KEY CONTROL button on the 1.
Remote Control.
The current key level (e.g. �KEY 0�) appears on the display.

23