|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is exactly what I needed This was a hard one to find and I had already downloaded several for other Panasonic radios but none matched my radio.
Although my radio is the LBE model the LBS is the same.
A very good quality manual with every thing you should get in it
;
el manual es correcto , completo y de buena calidad aunque algun esquema esta excesivamente diseccionado.
;
muy buen manual con multiples graficos y formas de onda ademas de muy completo y bien presentado.
 ;
As Always these people were very rapid and efficient. A great job helping hobbiest and workers!!! Thank you a lot!
;
Excellent printing quality.
A complete and very usefull service manual with all details.
GREAT SERVICE AT VERY LOW PRICE!
A+++++++++++++++++++++++++
3. Top Cover/Under Cover (1) (2) (3) (4) Remove the side cover. (Refer to Section 2-1-2.2) Disconnect one harness from the MEC-13 board. Remove one screw, then remove the six hooks. Remove the top cover in the direction indicated by the arrow.
2-1-3. Replacement of Main Parts
1. Replacement of SE-611 Board (1) Remove the side cover. (Refer to Section 2-1-2.2) (2) Disconnect one harness from the SE-611 board. (3) Remove the two screws, then remove the SE-611 board.
Top cover
Top cover
Hooks Harness MEC-13 board
Hooks
Harness
BVTP 3x12
Roller shaft B Align the mating faces Hole Align the mating faces
BVTP 3x6
SE-611 board
(4) Attach a new SE-611 board in the reverse order of steps (1) to (3). 2. Replacement of MEC-13 Board
Roller shaft A Hole Under cover
(5) Attach the top cover in the reverse order of steps (1) to (4). n When attaching the top cover, make sure to align the mating faces before inserting the roller shafts A and B into each hole.
(1) Remove the side cover. (Refer to Section 2-1-2.2) (2) Remove the top cover and under cover. (Refer to Section 2-1-2.3) (3) Disconnect the five harnesses from the MEC-13 board. (4) Remove the three screws, then remove the MEC-13 board.
BVTP 3x8 Harness Harnesses
Harness
MEC-13 board
Under cover
(5) Attach a new MEC-13 board in the reverse order of steps (1) to (4). 2-2 (E)
UYA-S90SF
|
|
|
> |
|
