|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
 ;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
;
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
SS-US501/SW-US501/UZ-US501
SECTION 4 TEST MODE
[TEST MODE]
Procedure: 1. Press the I/1 button on the main set once while pressing the [S-MODE] button on the remote commander (RM-Z7S101) and the [INPUT] button on the main set. 2. When the test mode is activated, �USB� and �VOL� are displayed on the liquid crystal display. 3. Press the [VOLUME +] button on the main set, and the display on liquid crystal display will change over from �VOL� to �LCD�, �SWP� �ALLOC�, version number, and �VOL� in this order (in reverse order if the [VOLUME -] button on the main set is pressed). 4. Press the [INPUT] button on the main set, and the displayed test item will start (except version display). 5. Press the I/1 button to turn the power OFF, and the test mode will be deactivated and the cold reset will be executed. Test Items:
Item VOLUME TEST Description The display on liquid crystal display changes over from �VOL� to �0�, �10�, �20�, �30�, �40�, and �VOL� in this order, and along with the change of display, the volume is also changed. The liquid crystal display all blink, and after 5 seconds, they return to original state.
LCD TEST
SWAP (DSP TEST) The input signal is outputted to 5.1ch speakers. This mode is deactivated if the [INPUT] button on the main set is pressed again. KEY ALLOC TEST If the button displayed on the liquid crystal display is pressed, the next button is displayed. When all buttons are pressed, the original display is restored. The version number of microcomputer software is displayed.
Version Display
Note: During the test mode, the APC (auto power control) turns ON, and it turns OFF if the [INPUT] button on the main set is not pressed for 5 seconds.
8
|
|
|
> |
|
