|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
complete part-lists and pcb layout, schematic diagram is good enlargable,
 ;
Excellent, fast delivery, excellent product. Good luck!
 ;
This manual is for the usa model only. But it is clear
, accurate and comprehensive, including board layouts and schematics.
I found it extremely useful for my mitsubishi dp-86da, but the same diagram would also work for the realistic lab5000 and hi fi 80. Thanks.
 ;
Great to have extra resources for Service Manuals, Now days you can really not trouble shoot efficiently without one , Wayne at IRIONS TV & ELECTRONICS REPAIR Clearwater , Fl. 33755 727-446-7955
 ;
For five bucks you can barely buy a hamburger. Or for the same five bucks you can buy a service manual. Much more useful. (and better for your health, depending on where you buy your hamburgers).
Yes, there are free manual sites out there, but if they don't have what you want, you have to pay.
And five bucks isn't much. Not for full specs, schematics and adjustment and parts replacement procedures.
My only criticism is that grayscale illustrations aren't well rendered, but I've seen worse.
Schematics and text are clear.
I'll be happy to purchase from here again.
Mike
[email protected]
TOSHIBA V 726B
Electrical Adjustments Cont�d
(3) Example of display � In case of 1234 hours.
2
www.u-view.co.uk
� In case of 4 hours.
Scart AV Switching Diagram
� When the Counter Reset button is pressed in the display period, the abnormality display data is initialized and �-� is displayed. The data displayed are as follows: Abnormality generation number
Electrical Adjustments (V-727B Only)
1. ADJUSTMENT PROCEDURES 1-1. Servo Circuit 1-1-1. When IT004 is Replaced When IT004 is replaced, the data in the VTR is required to memorize in the new one. So perform the following procedures.
Abnormal system control modes
1. Press the channel up/down buttons on the VTR simultaneously for more than 5s while the display blinks and the unit is in the power off mode. 2. And then within 2s, press the CANCEL button on the remote controller. 3. After displaying the address at the channel display area and the data at the minute display area, set the address to 12 using the channel up/down buttons on the remote controller. Next, set the data to d2 using the FF/REW buttons on the remote controller. The data goes up using FF button and down using REW button.
Fig. 1-1 Abnormal mechanism positions 4. Set each address and data in the table following the description above. Table 1-1
Address 24 25 26 27 28 0C Data 0A 03 15 0A 5A 7F
Positions 0, 2, 4 exist as mechanism positions. For example, 8 shows a position between 7 and 9 (between playback position and review position). 2-3-4. Cylinder rotation time display (1) Outline All the time for which the cylinder is ON is counted, memorized on EEPROM, and indicated on the display tube. (2) Display method � Press the �CH UP� and �CH DOWN� button on the main unit for more 5 sec. at the same time. � Next, within 2 sec. press the �STOP� button on the remote control. � The cumulative operation time of the cylinder will be displayed for 30 sec. The time unit is an hour.
5. Perform the adjustment described in the item �Playback Phase (PG) Adjustment�. 6. Pull out the power cord plug from the AC outlet once and insert the power cord plug into the AC outlet again. 7. Perform the channel presetting as the IT004 replaced has no channel data.
|
|
 |
> |
|