|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent transaction - clean document received - Thanks a lot
;
Manual is in German but complete. I needed this one to fix a long lasting problem with the internal PSU of the camera. Most of the capacitors begin to leak after a few years wich results in the inability to power on the camera. When you try to turn it on the power led flickers and the unit directly turns off. Thanks to this manual I was able to locate all bad cap's and to dis- and reassemble the camera without any problems.
 ;
We received the manual in a timely manner and it was exactly what we were expecting.
;
Excellant, finally this is want I need and searching for The service manual is fantastic and thank you to owner-manuals.com and its service. Price is reasonable. It's a bit slow on my end in downloading but manage to receive the whole manual without a break. once again, thanks.
;
Very good scanning quality. All schematics are very legible. Worth every cent !
VAA11901-R.3579.A
(Note) If the rack plate is removed or the cam is
Cam Rack plate
not in the right position, assemble the rack plate by following way. � Move the finder lens to the right end. � Set the horizontal line on the cam to the center of the cam shaft. � Assemble the rack plate by sliding it in a direction pointed by an arrow. � After assembling them, be sure to check the position as mentioned in Page A1.
Finder lens
3. Lens unit
â�¢ Attach the 3 pieces of spacers shown in Picture on the left to the lens unit. â�¢ Set the finder coupling pin and the claw of lack plate on the finder unit. Then attach the finder unit with the 3 screws â� (1.4 x 3.5). â�¢ Apply a piece of tape (brown) and spacer to the bottom of the lens unit.
Spacer
Finder coupling pin
Lens unit Finder unit Spacer(Brown)
â� Spacer(Brown) Spacer
Spacer
[Position where the tape and spacer should be applied.]
- A2�E4500 -
|
|
|
> |
|
