|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
;
You can fully trust on this one!
All the schematics are very crear an in one piece per page
;
I have never bought a service manual which is as competely readable as this althogh it was a scanned pdf. Thank you for this succesful manual also cheaper than other sites.
VAA11901-R.3579.A
(Note) If the rack plate is removed or the cam is
Cam Rack plate
not in the right position, assemble the rack plate by following way. � Move the finder lens to the right end. � Set the horizontal line on the cam to the center of the cam shaft. � Assemble the rack plate by sliding it in a direction pointed by an arrow. � After assembling them, be sure to check the position as mentioned in Page A1.
Finder lens
3. Lens unit
â�¢ Attach the 3 pieces of spacers shown in Picture on the left to the lens unit. â�¢ Set the finder coupling pin and the claw of lack plate on the finder unit. Then attach the finder unit with the 3 screws â� (1.4 x 3.5). â�¢ Apply a piece of tape (brown) and spacer to the bottom of the lens unit.
Spacer
Finder coupling pin
Lens unit Finder unit Spacer(Brown)
â� Spacer(Brown) Spacer
Spacer
[Position where the tape and spacer should be applied.]
- A2�E4500 -
|
|
|
> |
|
