|
There are currently no product reviews.
 ;
Good quality service manual.The scheme is on A3 format and very readable.Thank you
;
Very good service-manual with clear electrical diagrams. Thanks you.
 ;
the manual is in quite good quality and it's in pdf. manual was send in less then 6h.
;
Absolutely top, I've got now all Service-Manuals I'll need to repair my Mackie-Mixer!
;
The service manuel is very helpful, we where able to restore the device to its working operation again.
VAA11901-R.3579.A
(Note) If the rack plate is removed or the cam is
Cam Rack plate
not in the right position, assemble the rack plate by following way. � Move the finder lens to the right end. � Set the horizontal line on the cam to the center of the cam shaft. � Assemble the rack plate by sliding it in a direction pointed by an arrow. � After assembling them, be sure to check the position as mentioned in Page A1.
Finder lens
3. Lens unit
â�¢ Attach the 3 pieces of spacers shown in Picture on the left to the lens unit. â�¢ Set the finder coupling pin and the claw of lack plate on the finder unit. Then attach the finder unit with the 3 screws â� (1.4 x 3.5). â�¢ Apply a piece of tape (brown) and spacer to the bottom of the lens unit.
Spacer
Finder coupling pin
Lens unit Finder unit Spacer(Brown)
â� Spacer(Brown) Spacer
Spacer
[Position where the tape and spacer should be applied.]
- A2�E4500 -
|
