|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It was a complete manual as stated. Very good source for older product manuals. Thanks
;
Scan quality is very good. Price is very reasonable. If you're looking to purchase a copy of this manual, this is the one to get.
 ;
Perfect for my use.Could have better pictures,but otherwise perfect ;)
;
This is one of four manuals I have downloaded recently.
Purchase was very straight forward and the authorising email arrived in about 4 hours.
The quality of the scan is good. Print is clear and square to the page edges.
;
Exactly as advertized. High quality digital copy of the Nak 610 user manual. Easy download and access. Highly recommended.
Programming No additional programming is required for the DBS. However, if an automated attendant or other device performs the transfer, the automated attendant or other device must be set up to transfer your call by dialing #97****. Operation To access the system using the new RAI Access method: Note: The following procedure uses a preprogrammed automated attendant to transfer a call to the RAI. 1. At the PC terminal program, dial into the DBS through a normal trunk. 2. Follow the appropriate method to transfer to the RAI modem. Normally, an automated attendant will be configured to answer your call, play a message prompting a response (dial 1 to access Sales, 2 to ...etc.) where one of the responses will place you on hold and dial the #97**** access code to reach the RAI. 3. Wait a few seconds for the RAI modem to return the modem tone and for your terminal program to connect. 4. If Password> is not displayed, press the Enter key. 5. When Password> is displayed, dial the 4-digit remote or private password. 6. After the DBS responds with REMT>, type P and then press Enter. 7. Follow the directions on the screen to access the desired program. (See �Terminal Programming Commands�.) Note: The following procedure has the attendant manually transfer a call to the RAI. 1. Start your PC terminal program. 2. With a telephone connected to the modem, manually dial into the DBS through a normal trunk. 3. When the attendant answers, ask the attendant to dial #97**** to transfer your call to the RAI modem. 4. When you hear modem tone, enable your terminal program to connect (usually be selecting Connect). 5. If after a few seconds Password> is not displayed, press the Enter key.
DBS-2.3/9.2-700
DBS Manual - Revised April 2000
Page I-15
|
|
|
> |
|
