|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what was needed to assess the product - excellent value and great service
;
A site where discontinualed schematic diagrams and back dated information can be found on discontinued radios tv's and any electronic equipment can be found. Newer manuals either Service and operating manuals. Radio amateurs should find this site a great source for ham radio equipment manuals. I will return to this site should I need information on any electrical equipment. priced easy to download in a PDF format and print pages need to undertake the repair.
;
Quality scan of the original. All the detail necessary to troubleshoot, repair and adjust the unit. I'm sure I will be downloading more manuals in the future as the need arises.
;
Exactly as described, a Service Manual complete with the schematics and PCB layout delivered in a timely manner. Many thanks for the great service.
 ;
some of the writing is a bit blur but the part in the schmatic was great and i have fixed the machine thanks
VC-1130 VC-RH2130
FRONT PANEL PARTS
F
511
504
E
501
D
502 509
503
C
500
B
512
506
A
505
VC-RH2130 Only
1
2
3
4
5
6
PRECAUTION ON FRONT PANEL SET-UP
Cassette housing Front panel Cassette cover Cassette cover open lever Cassette cover open lever About 45° Cassette cover
3 4
Cassette cover open lever
1 2 5
Before attaching the front panel in position, make sure that the cassette cover open lever is in its right place (lower-most). If it is out of position, push it down with a finger.
Keep the cassette over about 45° open and make sure that the cassette cover open lever is between the front panel and the cassette cover. Now fix the front panel in place.
Do not mount the front panel with the cassette cover tilted too open. Otherwise the cassette cover might wrongly run on the cassette housing.
Removing the cassette compartment cover. 1 Open the cassette compartment cover fully. 2 Remove the center positioner. 3 Slide the cover to the right. 4 Slightly bend the cover. 5 Draw out the left-side rod.
5
|
|
|
> |
|
