|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
;
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
 ;
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
;
This manual is very well presented and after printing out looks about as close to an original as I think you can get. The quality is second to none.
The content of the manual is comprehensive and I think it would be well suited to an audio repair professional which I'm not but I did find it very informative and helpful.
The cost of the manual is more than covered by the money I'll save when I change the keep memory battery now I have the relavant info.
Very pleased with my purchase and can recommend it wholeheartedly as I can other manuals I've downloaded from this site.
Regards
Limey Alex
;
Complete manual including mechanical part in good pdf quality. Shaded greys of the pcb due to pdf not perfect but usable.
NO.12 FLOW CHART NO.14
The drum motor fails to run. No head switching pulse.
VC-A410U(B)/H810U(B) VC-A411U/H811U VC-A420U/H820U
Is the voltage more than about 2.6V NO DC given out pin(46) of IC701.
See FLOW CHART NO.13,14.
Check IC701. Is the drum motor rotating?
YES YES
Check PC 5V line. signal present on pins(66) and (65)
YES YES NO
Is the PG signal and drum FG Is the supply voltage of 5V feed to NO Are there drum PG M.M.signal at pin(3) IC706? pin(87) of IC701? of IC701, respectively? Check C753 and readjust R701. Check between pin(30) of IC701
YES
Is the voltage more than about 2.6V NO and all the way up to pin(2) of (HEAD SW. POINT control.) applied at pin(2) of IC706? IC706.
YES Replace IC701.
Is the supply voltage of feed to Check AT 12V line. pin(21) of IC706? Are the PG and drum FG YES
Could be lines between IC706
NO
NO
YES and IC701.
signals present on pins(7) and (8) of IC706? Check peripheral circuit of IC706.
Check or replace drum motor.
FLOW CHART NO.13
42
Replace IC706.
NO
The drum motor runs only for a few seconds.
Is drum PG signal given out NO Check pin(4), (5), (6) of IC706 and pin(7) of IC706? periperal circuits.
YES
Check or replace drum motor.
Is drum PG signal given out of
pin(66) of IC701?
Check line between pin(7) of IC706 NO and all the way up thru to pin(66) of IC701.
YES
Is V-H.SW.P pulse given out of NO Check IC701. pin(23) of IC701?
YES
Replace IC701.
|
|
|
> |
|
