|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The owners manual for the Pioneer VSX-D603S was exactly what I needed. I received it in a timely manor and it was priced fairly. I definately will use your servise again. Thank You
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
Cutting Height Adjustment
Wheels - Front Cutting Height Adjustment � Height of cut is adjusted by raising or lowering the front wheels and rear roller. � NOTE The wheels and the roller must be adjusted to the same position: HEIGHT OF CUT WHEEL ROLLER Low Hole 1 Position H Medium Hole 2 Position J High Hole 3 Position K � NOTE A medium height of cut is recommended for most lawns. 1. To remove the wheel assembly turn the wheel hub in an anti-clockwise direction.(E) 2. Select one of the 3 holes in the mounting plate and note it as the other wheel will need to be adjusted to the same position.(F) Locate fixing bolt through hole in hub cap, wheel and selected hole in mounting plate.(F) Turn the wheel hub in a clockwise direction until
E
to remove turn anti-clockwise
to fit turn clockwise wheel
F
mounting plate hub cap
3. 4.
1 2
holes
3
fixing bolt
the wheel assembly is securely located to the deck.(E) 5. Using the same height adjustment position repeat the procedure for the other wheel. Roller and Rear Height Adjustment H - LOW J - MEDIUM K - HIGH 1. Select one of the 3 locations and note it as the other lever will need to be adjusted to the same position. (H, J or K) 2. Lift the lever out of location and rotate the roller to the desired position. (G) 3. Using the same height adjustment position repeat the procedure for the other lever.
G
H
J
K
Grassbox
Fitting Fully Assembled Grassbox to Lawnmower. See Fig L. 1. Lift safety flap. 2. Make sure the discharge chute is clean and free from debris. 3. Locate fully assembled grassbox onto 2 location points at the rear of the deck 4. Locate safety flap onto the top of the grassbox. Ensure the grassbox is securely located. � IMPORTANT ! AFTER FITTING ENSURE NO GAP REMAINS BETWEEN THE SAFETY FLAP AND THE GRASSBOX. � Removal is the reverse procedure. � For larger areas of grass where grass collection is not required you can use your lawnmower without the grassbox. Ensure the Safety Flap is fully closed. The design of the safety flap permits the cut grass to be discharged downward behind the machine.
L
|
|
|
> |
|
