|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
;
excellent value & price! Includes everything you need to know about the NN-C777! I would buy this again.
;
Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Appendix (Installing the optional CD-RW drive)
How to install the CD-1A
<Notes on installing the CD-RW drive>
� The CD-RW drive is made of precision parts. Do not apply a mechanical shock or use excessive force when installing it. � Before installing the drive, make sure that the power of the VF80 is off and the power cord is disconnected. � Install the drive correctly according to this manual. Note that damage to the drive caused by inappropriate installation is not covered by the guarantee.
1
Remove the side cover of the VF80 by unfastening the two screws using a screw driver.
After removing the cover, remove the blank panel attached inside the cover. Retain the cover which will be used later.
3
Insert the CD-1A unit to the VF80 as shown below.
Carefully insert the CD-1A to the VF80 in the right direction, without rubbing it against the VF80 cabinet. Push the unit carefully and firmly with your both hands, but without excessive force, until you feel the connector of the CD-1A mesh with the internal connector.
Connector Cover
Insert the CD-1A
4
Blank panel
Using the screw (1 pc.) which tightened the blank panel to VF80, fix CD-1A to the VF80 chassis.
Fasten the screws without excessive force.
2
Remove the metal fitting by unfastening the retaining screw (indicated by an arrow) inside the CD-1A.
Because the screw head is small, use a micro screw driver to carefully unfasten the screw without damaging the head by excessive force.
CD-1A
5 6
Fix the cover removed in step 1.
Connect the power cable of the VF80 to an AC main outlet, and turn on the power.
Check that the VF80 starts up and the indicator on the front panel of the CD-1A flashes for a few seconds and then turns off. Do not operate the CD-1A unit the VF80 display shows the Normal screen after showing the start-up screen.
135
|
|
|
> |
|
