|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent copy that was delivered within 12 hours and solved my problem.
 ;
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
;
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
;
Finding the owners manual for my Pioneer CRWM62R is greatly appreciated. I had searched several other web sites with no success. Although my manual was not listed on your site for immediate download, I recevied an email within a few hours that my ower's manual was posted for me. I had no difficulty downloading the manual for my 20 year old multi-cassette player. Owner Manuals provides a service that is valuable, easy-to-use, accurate , efficient, and priced fairly. I thank you.
;
Excellent manual - just what I needed. Although currently available only in German, their are lots of pictures which makes it all very clear.
Programming Tutorial Editing Presets
100 80
Cutoff Frequency
Output of Filter
Amplitude
60 40 20
40
80
160 360 720 1440 2880 ...
Frequency
3. 4.
Open the �lter back up to 255, then move the cursor to the Q �eld. Set the Q to 10, then move the cursor back under the Freq value. As you change the frequency, notice that the sound now has a sharp, nasal quality. A high Q boosts or ampli�es the frequencies at the cutoff frequency (Fc). Reset the cutoff frequency to the lowest setting (0.08Hz) and the Q to 00.
5.
Adding the Filter Envelope
Now let's modulate the Filter Frequency with the Filter Envelope. The Filter Envelope is a device that can automatically change the �lter frequency during the course of the note. Before we de�ne the Filter Envelope, we need to patch the Filter Envelope to the Filter Frequency.
To Setup the Filter Envelope
1.
Go to the PatchCord screen.
L1
PATCHCORD -> AmpVol
#01 +100
RlsVel
2.
3.
Move the cursor below the �rst �eld in the bottom line of the display. This is the Source �eld. Use the Data Entry Control to change the Source to �FiltEnv� as shown in the following illustration. Advance the cursor to the next �eld. This is the Destination �eld. Use the Data Entry Control to change the destination to �FiltFreq.�
138 E-MU Systems
|
|
|
> |
|
