|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Exactly what I needed to be able to bring the amp back to life... will come back to this site the next time I need schematics.
;
Information was accurate and very helpful.
However the continuity made it a little difficult to follow from one page to the next.
 ;
Very very good as usual very trustable site. Perfect!!!!!!
;
The Service Manual received was helpful. Good copy of original document.. I recomend all of my friends about this technical page.
;
Perfect, complete manual, exactly what I needed. Recommended to everyone.
VL-H870U VL-H875U VL-H890U
VL-H870U VL-H875U VL-H890U
4-2. REMOVAL OF THE CAMERA PARTS
Note: Before removing the Cabinet, turn off the power supply,and ascertain that the battery has been removed.
(b) (d) (c) (c)
(a)
(c)
(b) Pull out (d) Pull out Camera front cabinet
1. Remove the screws (b)LX-HZ0018TAFF(1pc.),(a)LX-HZ 0018TAFN(1pc.),(c)LX-HZ0045TAFN(1pc.)and (d)XiPSF20P04000(1pc.), pull out the Front cabinet.
Speaker connector
(g) Camera rear grip cover
Remove
4. Remove the screws(b)LX-HZ0018TAFF(1pc.),(c)LXHZ0045TAFN(2pcs.)and (d)XiPSF20P04000(1pc.),pulling out the Camera rear Cabinet, and remove the Speaker connector.
(c)
(g)
2. Remove the screws (g)LX-HZ0045TAFF(2pcs.) and the Camera rear grip cover .
Battery catcher connector Pull out
Connector
Tilt Frame C
Claw
3. Remove the connector.
5. Remove the screw(c)LX-HZ0045TAFN(1pc.)and pull out the Tilt Frame C. Pull out the Tilt Frame C. at right angle, because of closing the claw. Then, pull out the battery catcher connector from the Tilt Frame C.
4-4
|
|
|
> |
|
