|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent manual. In addition to the information I needed was a complete description of both electronic and mechanical devices.
Excellent site.
Thank you very much.
 ;
very good and complete manual , it is in english and german is perfect for repair.
;
This manual is complete and of high quality. I am very pleased with the purchase.
;
Another excellent buy! A fully readable PDF archive. Good prints!!
;
It is wonderful done!!! a great job in scanning the manual. Superior quality in all the electric scheme. Very understandable and net!!! Thank you!
VL-H875T VL-H890T
VL-H875T VL-H890T
3-2. REMOVAL OF THE CAMERA PARTS
Note: Before removing the Cabinet, turn off the power supply,and ascertain that the battery has been removed.
(b) (d) (c) (c)
(a)
(c)
(b) Pull out (d) Pull out Camera front cabinet
1. Remove the screws (b)LX-HZ0018TAFF(1pc.),(a)LX-HZ 0018TAFN(1pc.),(c)LX-HZ0045TAFN(1pc.)and (d)XiPSF20P04000(1pc.), pull out the Front cabinet.
Speaker connector
(g) Camera rear grip cover
Remove
4. Remove the screws (b)LX-HZ0018TAFF(1pc.), (c)LXHZ0045TAFN(2pcs.) and (d)XiPSF20P04000(1pc.), pulling out the Camera rear Cabinet, and remove the Speaker connector.
(c)
(g)
2. Remove the screws (g)LX-HZ0045TAFF(2pcs.) and the Camera rear grip cover .
Battery catcher connector Pull out
Connector
Tilt Frame C
Claw
3. Remove the connector.
5. Remove the screw (c)LX-HZ0045TAFN(1pc.)and pull out the Tilt Frame C. Pull out the Tilt Frame C. at right angle, because of closing the claw. Then, pull out the battery catcher connector from the Tilt Frame C.
3-4
|
|
|
> |
|
