|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
VL-NZ50S/H/E/W/NZ80H VL-NZ100S/H/E 5. 7.
(i) (c) Microphone Cover Camera Front Cabinet (c) (o)
Mechanism
NZ50S/H/E/W
(i) (i) NZ80H/NZ100S/H/E
(i)
(i) (i)
(i)
(k)
(c)
(k)
(h)
(k)
(c)
Camera Rear Cabinet
Camera Rear Cabinet (c)
(m)
1) Take the mechanism out. 2) Remove the 3 floating screws A ((k)LX-BZ0251TAFD) and 1 floating screw B ((m)LX-BZ0253TAFN).
6.
1) Remove the 3 screws ((c)XiPSN17P03000), 4 screws ((i)XiPSF17P03000) and 1 screw ((h)XiPSF17P02000) (NZ50S/H/E/W only) fixing the camera rear cabinet to detach it. (Note: When detaching the camera rear cabinet, pay attention to the FPC of the camera operation unit.) 2) Remove the 2 screws ((i)XiPSF17P03000) and detach the camera side cover in the direction of the arrow. (Note: When detaching the side cover, pat attention to the lead wire of the speaker.) 3) Remove the 1 screw ((i)XiPSF17P03000) and 1 screw ((o)XiPSN17P06000) and detach the microphone cover in the direction of the arrow. (Note: When detaching the microphone cover, pay attention to the lead wire of the microphone.) 4) Remove the 2 screws ((c)XiPSN17P03000) and camera front cabinet.
8.
Lithium Holder
(r) (r) Lithium PWB Unit
(c) (c) Power SW Unit
1) Remove the lithium holder and 2 screws ((r)XiPSN17P04000) to detach the lithium PWB unit.
1) Remove the 1 screw ((c)XiPSN17P03000) to detach the power SW unit. (Note: When detaching the power SW unit, pay attention to the FPC.) 2) Remove the 1 screw ((c)XiPSN17P03000) to detach the lens unit.
5
|
|
|
> |
|
