|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
A very well written and easy to understand manual.
;
There was no problem at all.After paying i had to wait only a few hours,than i could
download the manual in best pdf-quality.
Thank You !
 ;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
VL-PD3AS/AH/AE
3. DISASSEMBLY OF THE SET
Note: Before removing the cabinet, turn off the power supply, and ascertain that the battery have been removed. 1. 5.
V/F section
(D) (D) (D) (C) (D)
(G)
· Remove the screws ((D)XiPSF17P03000)(4pcs.) of the bottom · Up the section of V/F, and remove the screw ((D)XiPSF17P03000) cover and them. (1pc.). · Remove the screws ((D)XiPSF17P03000)(2pcs.) and ((C) 2. XiPSF1704000)(1pc.). · Remove the screw ((G)XiPSN17P03000)(1pc.) and battery cover.
(F)
6.
(F)
(D)
(B) (F) (R)
· Remove the screws ((F)XiPSN17P04000)(3pcs.), ((B)LXHZ0050TAFN)(1pc.) of the front cover and the DV terminal's screw ((R)XiPSN16P05000)(1pc.).
3.
Remove the claw
(D)
(D)
(D)
· Remove the screw ((D)XiPSF17P03000)(1pc.) of topside and open the cassette compartment door, remove the screws ((D)XiPSF17P03000) (3pcs.) of both sides and center screws. Remove the Remote control receiver unit connector, the Zoom FPC, the EJECT switch connector, the H/A connector, and the cabinet A.
(B)
7.
(D)
· Open the LCD panel, remove the screws ((B)LX-HZ0050TAFN) (2pcs.), the claws what is connected the cabinet A and remove the front cover. Be careful so that not damage the lead wires of microphone when it removes the front cover.
(H)
4.
(G) (G)
· Remove the screw ((D)XiPSF17P03000)(1pc.) topside of cabinet B and the screws ((H)XiPSN17P02000)(1pc.) of side surface and ((G) XiPSN17P03000)(1pc.) of rear surface.
Microphone connector
(Note.) In case of disassemble or assemble the section of V/F, do the work with great care that there are never taint or intermix of dust.
· Slide the section of V/F, and remove the plate of topside, the screws ((G)XiPSN17P03000)(2pcs.), and remove the top cover what is slided toward V/F slide.
4
|
|
|
> |
|
