|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The document was usefull, and it was exactly what I was looking for.
;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
1-12
Projecting
To turn off the power
4 5
Turn the zoom ring to adjust the size of the picture. Turn the focus ring to adjust the focus.
1
Press the I / u key on the Remote Commander or on the control panel. The following message appears to confirm if you want to turn off the power.
Note
Do not look into the lens when the projector lamp is on. To Adjust the volume Cut off the sound Press the VOLUME +/� keys on the control panel or on the Remoter Commander. the AUDIO MUTING key on the Remote Commander. To restore the sound, press the AUDIO MUTING key again or press the VOLUME + key. the PICTURE MUTING key on the Remote Commander. To restore the picture, press the PICTURE MUTING key again.
POWER OFF? P l ea s e p r e s s
key / u i n . I aga
Note
The message will disappear if you press any key except the I / u key, or if you do not press any key for five seconds.
Cut off the picture
2
Press the I / u key on the Remote Commander or on the control panel again. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce the internal heat. Also, the ON/ STANDBY indicator flashes quickly for the first 30 seconds. During this time, you will not be able to turn the power back on with the I / u key.
To get the clearest picture
You can adjust the dot phase when a signal from the computer is input.
For details on DOT PHASE, see page 27 (EN).
3
1 2
Press the DP key on the control panel. Press the B/b key on the Remote Commander or on the control panel to adjust the dot phase. Adjust the picture to where it looks clearest.
Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red.
When you cannot confirm the on-screen message When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / u key on the Remote Commander or on the control panel for about one second.
You can also adjust the dot phase through the menu.
For details, see �The INPUT SETTING menu� on page 27 (EN).
Note
Do not unplug the AC power cord while the fan is still running; otherwise, the fan will stop although the internal heat is still high, leading to breakdown of the projector.
22 (EN)
23 (EN)
|
|
|
> |
|
