|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
1-12
Projecting
To turn off the power
4 5
Turn the zoom ring to adjust the size of the picture. Turn the focus ring to adjust the focus.
1
Press the I / u key on the Remote Commander or on the control panel. The following message appears to confirm if you want to turn off the power.
Note
Do not look into the lens when the projector lamp is on. To Adjust the volume Cut off the sound Press the VOLUME +/� keys on the control panel or on the Remoter Commander. the AUDIO MUTING key on the Remote Commander. To restore the sound, press the AUDIO MUTING key again or press the VOLUME + key. the PICTURE MUTING key on the Remote Commander. To restore the picture, press the PICTURE MUTING key again.
POWER OFF? P l ea s e p r e s s
key / u i n . I aga
Note
The message will disappear if you press any key except the I / u key, or if you do not press any key for five seconds.
Cut off the picture
2
Press the I / u key on the Remote Commander or on the control panel again. The ON/STANDBY indicator flashes in green and the fan continues to run for about 90 seconds to reduce the internal heat. Also, the ON/ STANDBY indicator flashes quickly for the first 30 seconds. During this time, you will not be able to turn the power back on with the I / u key.
To get the clearest picture
You can adjust the dot phase when a signal from the computer is input.
For details on DOT PHASE, see page 27 (EN).
3
1 2
Press the DP key on the control panel. Press the B/b key on the Remote Commander or on the control panel to adjust the dot phase. Adjust the picture to where it looks clearest.
Unplug the AC power cord from the wall outlet after the fan stops running and the ON/STANDBY indicator lights in red.
When you cannot confirm the on-screen message When you cannot confirm the on-screen message in a certain condition, you can turn off the power by holding the I / u key on the Remote Commander or on the control panel for about one second.
You can also adjust the dot phase through the menu.
For details, see �The INPUT SETTING menu� on page 27 (EN).
Note
Do not unplug the AC power cord while the fan is still running; otherwise, the fan will stop although the internal heat is still high, leading to breakdown of the projector.
22 (EN)
23 (EN)
|
|
|
> |
|
