|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
SETTING UP
Setting the Video Channel
This VCR is designed to send picture and sound signal on UHF channel E36 to the TV, through the RF coaxial cable. If you want to change this video channel (E36) to another channel (between E28 to E60), follow the procedure below before turning on the VCR for the first time.
1 Make sure the VCR is turned off and no cassette is inserted. 2 Turn on the TV, and tune it to any channel (UHF E28 to E60) you want to use as the video channel on the TV.
� Select a channel not used in your area.
3 Press STOP/EJECT 7 /0 on the front panel for more than 5 seconds.
The following indication appears on the display.
TV system number starts flashing.
4 Press CH 5 / � to select an appropriate TV system number for your area.
1: For B/G (West Europe, ASEAN Countries, Australia, New Zealand). 2: For D/K (China, Russia, East Europe). 3: For I (Hong Kong, South Africa, United Kingdom).
5 Press 3/OK.
The channel number starts flashing on the display.
Channel number starts flashing.
6 Press CH 5 / � to select the channel you have tuned on the TV as the video channel in step 2.
A test signal (two vertical white bars) appears on the TV.
If you use only external video input (AV) mode to watch the picture from this VCR You can turn off the video channel output. To turn off the video output channel, press CH � until �� �� appears on the channel number position.
Test signal (two vertical white bars)
7 Press 3/OK to finish the video channel setting.
Now you will enter the Initial Setup mode explained on page 11. To watch a picture from this VCR on the TV, select the same channel you have selected as the video channel (in step 2 above) on the TV.
� 10 �
VR288/488-55 EN (N) 10 5/31/99, 3:15 PM
|
|
|
> |
|
