|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
;
Great job supplying the manual.
Many of these products weerepretty obscure, so it was great that you had
the manual for it!
;
Great manual, would not have been able to operate my machine without it!!
James Dawson August 18, 2012
In case of difficulty Tuner
Symptom Radio stations cannot be received. Cause � No antenna is connected. � The broadcast band is not set properly. � The frequency of the desired station is not tuned. � Noise due to ignition noise from an automobile. � Noise due to interference from an electric appliance. � Noise due to a nearby TV set. A station which was preset cannot be received by pressing the corresponding numeric key. � The preset station belongs to a frequency that cannot be received. � The preset memory was cleared because the power cord had been unplugged for a long period of time. Remedy � Connect an antenna. ( � Set the broadcast band properly. � Tune the frequency of the desired station. � � Install the outdoor antenna away from the road. � Turn off the power to the appliance. � Install the receiver farther away from the TV. � Preset a station with a receivable frequency. � Preset the station again.
Interference.
Remote control unit
Symptom Certain inputs cannot be selected using the remote control. Remote control operation is not possible. Cause � No setup codes registered for the respective input(s). � The remote control unit is set to a different operation mode. � Batteries are exhausted. � The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle between the receiver and the remote. � No disc or tape is placed in the source component. � An attempt is made to play a tape which is being recorded in the cassette deck. � The remote control has not been set to the operation mode for the component you wish to control. Remedy � Register a setup code at the respective input(s). w � Press the RCV MODE key to select the appropriate operation mode. � Replace with new batteries. � Operate the remote control unit within the controllable range.
� Place the disc or tape in the source component which you want to play. � Wait until recording has completed. � Press any of the Source keys or SOURCE key to activate the operation mode for the component you want to control before operation. w
54 EN
|
|
|
> |
|
