|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
the manual was very helpful thank you very much no one else was able to help me thanx
;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Initial Set Up
CROSSOVER NETWORK
The following steps show you how to adjust the crossover network. The crossover network is the frequency at which the system divides the signal and sends the different parts (high, mid, low) to different speakers. Speaking precisely, this setting sets the cutoff point for the bass frequencies rerouted from your SMALL speakers to your subwoofer or speaker set to LARGE. If continuing from CHANNEL LEVEL go to step 1. If starting fresh, complete steps 1-3 in �Setting Up for Surround Sound� (p.30) first.
System Setup
DIGITAL INPUT SELECT SPEAKER SETTING CHANNEL DELAY CHANNEL LEVEL
BACK
1
CROSSOVER NETWORK BASS PEAK LEVEL MANAGER DYNAMIC RANGE CONTROL
1 Press the CROSSOVER NETWORK button. 2 Choose a crossover frequency.
Setting speakers to SMALL in SPEAKER SETTING sends the respective channel's bass frequencies to the subwoofer or the speakers you have selected as LARGE. This function lets you determine which frequencies will be sent to the subwoofer or LARGE speakers. Press 80 Hz, 100 Hz, or 150 Hz. The default setting is 80Hz. 80 Hz Sends bass frequencies below 80 Hz to the subwoofer (or LARGE speakers). 100 Hz Sends bass frequencies below 100 Hz to the subwoofer (or LARGE speakers). 150 Hz Sends bass frequencies below 150 Hz to the subwoofer (or LARGE speakers). As noted on the LCD screen the THX setting is 80. Select this setting if you have THX approved SMALL speakers. Experiment with the different settings to see which sounds best to you.
2
3
3 Press the SETUP OK button to return to the SYSTEM SETUP MENU.
The display on the amplifier reads RECEIVED. If "ERROR" flashes in the display, perform the setup operations from the first step again.
SIGNAL SELECT
ANALOG SP A
VOLUME
UP SET
dB
This information will be displayed on your TV.
Crossover Network Frequency [ 80Hz]
(THX Speaker = 80Hz)
Next, proceed to BASS PEAK LEVEL MANAGER below. If you want to change a setting before proceeding Start over from step one.
37
En
|
|
|
> |
|
