|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
;
Another excellent buy! File too clear and explanatory.
 ;
A manual hard to find. It was very helpful to restore my device.
;
I am very grateful for this manual. Without it could not repair my receiver.
;
excellent work as always you do cheap, fast net and clean. you do an incredible service......thanks!
2-1-5. How to Attach the Hard Disk Drive Unit (BKSH-102G)
Notes: 1) The six hard disk drive (HDD) units are installed in the media unit (VSH-1000) when the media unit (VSH-1000) is connected to the media control unit (VSR-1000) and used. 2) A maximum of six HDD units can be installed in a media unit when a media unit (VSH-1000) is connected to the MPEG-2 encoding unit (VST-1000/1000P) and used. 3) Never subject the HDD units to severe shocks. 1. Confirm that the POWER switch of HDD unit is in the OFF position. 2. Remove the four screws and remove the front panel. 3. Remove the two screws and remove the blank panels. Note: Remove the blank panels corresponding to the HDD units to install.
Screws PSW 3�8
Screws B 3�6
Front panel
Screws B 3�6
4. Align the rails of the HDD unit with the guide rails of the unit. 5. Move the top eject lever of the HDD unit in a level. Insert the HDD unit until the eject lever contact the unit with the bottom eject lever opened in the direction shown by arrow 1. 6. Insert the eject levers in the direction of arrow 2 and lock them. (The HDD unit is inserted to its end.)
(Lever in a level)
Guide rail
Rail
Guide rail 2 HDD Unit Power switch 1 Eject lever
Media unit
2-4
|
|
|
> |
|
